DROPLET V8.18 Seeeduino Xiao RFM Shield breakout board PCB
€3,49
DROPLET V8.18 Seeeduino Xiao RFM Shield breakout board PCB Create a simple LoRa IOT Node with this interface PCB. This board is perfect for learning and experimenting with LoRa. The PCB makes all the necessary connections for the LoRa module. Just add a Seeeduino Xiao and a HopeRF RFM95/92 LoRa module to the PCB and you are ready to go. At the bottom of the PCB you can connect different types of sensors and modules.
This board is tested with the following libraries:
https://github.com/mcci-catena/arduino-lmic
https://github.com/sandeepmistry/arduino-LoRa
Specsheet PDF
In stock (can be backordered)
Power supply:
Use the XIAO USB connector as power supply. The XIAO regulates the voltage down to 3.3v for the RFM module.
At the bottom of the PCB are extra connections for powering sensors or other modules.
The RFM only works on 3.3 volt. Higher voltage will damage your LoRa module!!
Connections:
The PCB makes all the necessary connections from the XIAO to the RFM module.
MISO, MOSI and SCK are connected to the standard pins.
The only thing you need to change in your sketch are the DIO and the NSS pins
| RFM | XIAO |
| DIO0 | A2 |
| DIO1 | Jumper X-3 to A3 |
| DIO2 | Jumper X-3 to A3 |
| NSS | A1 |
| MOSI | A10 |
| MISO | A9 |
| SCK | A8 |
| RST | Jumper X-0 to A0 |
This board is tested with the following libraries:
https://github.com/mcci-catena/arduino-lmic
https://github.com/sandeepmistry/arduino-LoRa
Change the pin-mapping in your sketch to mach with the pin-out table above. (DIO0 optional DIO1, DIO2 and Reset)
If you use the LoRa-lmic library you must provide your – network session key, application session key and device address.
| Weight | 10 g |
|---|---|
| Dimensions | 6 × 2 × 2 cm |
Only logged in customers who have purchased this product may leave a review.
Related products
Bare Boards
Reviews
There are no reviews yet.