First proto LoRa PCB test

After many expermints with LoRa we came up with the idea to design our own PCB. This is the first proto version of the board.
We use the Arduino Pro-mini 3.3v and the HopeRF RFM95 LoRa module. The Arduino regulates the power to 3.3v for the RFM95 (The RFM95 cannot handle 5v). The necessary connections from the Arduino to the RFM95 are made by the PCB so no hassle with wires.  For the power suply we use  a standard 5v USB powerbank to the RAW pin of the Arduino.  The sketch we use is can be found here
The MISO, MOSI and SCK are standard pins on the Arduino we only needed to change the DIO and the NSS pins in the Pin Mapping section of the sketch.

RFM95 pins Arduino pins
DIO0 PIN – 7
DIO1 PIN – 8
DIO2 PIN – 9
NSS PIN – 10

We connected the node to by changing the Networksession key, application session key and the device address at the top of the sketch uploaded the sketch to the Arduino and its alive it sends a Hello World message to the things network.
Beacause there are not so many gateways around us we took the node to a watchtower we use the TTN-Mapper app to see if we have connection and to measure the distance to the gateway the antenna we used is a simple 8.2cm copperwire. And yes we got connection about 15KM to 2 gateways
See the full report on the website of TTN mapper.


2 thoughts on “First proto LoRa PCB test

  1. Suhail Asim says:

    I have successfully made this device and its shows on serial monitor sending data to TTN but from other side no response and it results packet in queue . may i send picture of serial monitor result? to check the problem.

    • Mans van Wijk says:

      Could you please send me your screenshot?
      Are you sure you have placed your own ID in the firmware?
      Maybe you are not in range of an access point?

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

This site uses cookies to offer you a better browsing experience. By browsing this website, you agree to our use of cookies.